2020/7/21/ / Last updated : 2021/2/8/ Gene BGP Basic Configuration and Verification Commands The basic configuration process for BGP consists of the following three steps 1. Enable the BGP routing process 2. Configuring the Neighbor 3. Generating BGP routes
2020/7/10/ / Last updated : 2021/2/8/ Gene EIGRP Basic Configuration and Verification Commands This page explains the basic EIGRP configuration commands and their verification commands.
2020/3/3/ / Last updated : 2021/8/13/ Gene OSPF Cost Configuration and Verification The metric for determining the best route in OSPF is the path cost. It is the cumulative cost of an interface on a route. This section explains the concept of path cost and how to change and check the cost on a Cisco router.
2020/2/27/ / Last updated : 2022/1/14/ Gene debug command to verify real-time operation The debug command is used to check the operation of a router/switch in real time.
2019/12/15/ / Last updated : 2021/2/8/ Gene Cisco Configuring and Verifying VLAN This section describes how to configure and verify VLANs in Cisco. Let’s imagine how VLANs and ports are connected inside the switch by VLAN configuration.
2012/3/23/ / Last updated : 2021/2/8/ Gene Advertising default route by EIGRP : ip default-network command How to generate default routes in EIGRP There are several ways to generate a default route as an EIGRP route a […]
2012/3/16/ / Last updated : 2021/2/8/ Gene Advertising default route by EIGRP : route summary This is a configuration example of route summarization as a way to generate a default route in EIGRP.
2012/3/9/ / Last updated : 2021/2/8/ Gene Advertising default route by EIGRP : redistribute static This is a configuration example of redistributing the default route of a static route as a way to generate a default route in EIGRP.
2005/1/7/ / Last updated : 2021/2/8/ Gene OSPF Basic Configuration and Verification Commands There are two basic configuration procedures for OSPF 1. Enable the OSPF routing process. 2. Enable OSPF on the interface
